Casting With Alumilite Clear Slow | Live Stream 7.7.2020

Last night I cast a few blanks with Alumilite clear slow using Caster’s Choice Mica Powders. In total, I was able to cast three dye-stabilized elm burl blanks, four ring blanks, and a few other resin only blanks. It was a productive casting session and I am pretty excited about the results. If you see any blanks on my website, or social media platforms, feel free to reach out to claim the blanks.

Last Week’s Live Stream: Last week I refinished two pens. One pen was a mini bolt action pen and the other pen was a Zen rollerball. These pens were refinished and look like a million bucks now that they have a proper CA finish on them. I’m proud of how they turned out and am very pleased with the result.

New Tool: I was able to acquire the Ryobi AC 4 volt quick turn screwdriver. This will make screwdriver applications just a bit faster. I can’t wait to put this tool to use. An amazon affiliate link is on this website under the “Tools I Use” tab.

This Week: This week I cast three dye-stabilized elm burl pen blanks and the extra resin went toward other pen blanks and ring blanks. To prep the burls, I put a dab of hot glue on the bottom of each burl piece so they wouldn’t float in the mold. The three colors I used were from Caster’s Choice and they were gold, lime green, and white pearl.

I mixed 90 grams of A and 90 grams of B into each of the three colors. Once the resin got up to about 95-100 degrees Fahrenheit, I poured the three colors into an old sports drink container to give the colors a chance to mix and form a fun pattern. When I got all of the colors poured into one cup, I then poured the resin from the single cup into each of the molds I had ready to go. Because I used Alumilite clear slow, I left the blanks in the pressure pot for four hours so they could properly cure.

These pen and ring blanks were cast during a live stream on 7.7.2020. Caster’s Choice colors were used and the hybrids are made from dye-stabilized elm burl.

Supporting the Channel: Huge shout out to my top tier patrons, Mark and Angi! If you are interested in becoming a patron at any level, you can simply click the link here: Become a Patron!

You can also support the Cross Cut Creations shop in other ways. Participating in live streams and commenting on videos are a great FREE way to support what I do. If a monthly subscription to Patreon isn’t for you, that’s not an issue. There is a donate button on the right hand side of this website if a one time donation is a better option. Another way to support what I do is to buy something from my online store, also found on this website. Finally, a last way to support what I do without spending anything extra is to use my Amazon affiliate links. If you click on an affiliate link (found in the description of YouTube videos AND under the Tools I Use tab on this website), anything you purchase using that link will give me a small commission and add NOTHING to your total. All you pay for is the items you put in your cart and purchase. You don’t even have to buy the tool that you click on.

Thank you to all those who interacted during the live stream. I appreciate all of you and appreciate everyone who watches the replay as well. If you have any questions or comments, feel free to reach out to me and I’ll get back to you. If you want to check out the replay of the live stream, you can watch it below:

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.